Search:

Type: Posts; User: AcadDude

Search: Search took 0.12 seconds.

  1. Replies
    4
    Views
    965

    I cannot remember how many buttons are minimum....

    I cannot remember how many buttons are minimum. I have 6 mapped. Primary Action, Go Back, Tertiary Action, Secondary Action, Left Shoulder, DPAD Left.
    I mapped the plunger to the right analog and...
  2. Replies
    4
    Views
    965

    I set mine up as a steam generic controller. I...

    I set mine up as a steam generic controller. I set all the buttons in the steam controller setup.
  3. If you switch out of cabinet mode then you have...

    If you switch out of cabinet mode then you have to reenter the code you were given before to get back to cabinet mode
  4. Replies
    4
    Views
    1,165

    Be sure to check the settings "Backglass...

    Be sure to check the settings "Backglass repositioning" and "Dot matrix repositioning" are set to on. Otherwise it is a math problem to whether or not you have negative or positive values due to...
  5. Replies
    399
    Views
    72,605

    Party Zone I keep getting ball stuck in left...

    Party Zone

    I keep getting ball stuck in left Ozone ramp. It tries to push the ball up and over but stays there through a minute of resets until it finally has enough to get back into play.
  6. Replies
    0
    Views
    2,039

    Pinball Cabinet Home Built

    This is my home built cabinet. Playfield is 4k 49" TV monitor. DMD is 15.6 monitor USB monitor (1366x768). Backglass monitor is 32" monitor (1920X1080)

    This runs FX3 pretty well. This is actually...
Results 1 to 6 of 6